Plug the Polaron into your computer's USB port to upload Arduino program sketches into your Proboard 328P or Proboard PB. Each unit comes with an interconnecting sketch upload cable which can also be purchased separately.
Polaron's Transistor Transistor Logic (TTL) connector is polarized to prevent reversed connections, but it also works fine using generic non-polarized jumper wires. The design includes a genuine FTDI chip, so there is no need to install a driver into Windows. It has an extra robust 3.3V regulator onboard, and a self-resetting fuse for safety. It can supply either 5.0V or 3.3V for powering breadboard projects. The reset signal for uploading Arduino sketches can be switched to either DTR or RTS mode. Check out the datasheet for more information.
-------------------
Moyina Description: Built-in a new and original FTDI IC device ‘FT232RL’, which handles all the USB signalling and protocols. TTL levels of +5V and +3.3V adjustable design, and draws power directly from your PC/laptop via the USB connection, no need for an external power adapter
Provides access to UART Transmit (Tx), Receive (Rx), RTS#, CTS#, VCC and GND connections; POW(power), RXD/TXD transceiver communication LED indicator design, which can show serial adapter status and data activity at a glance
Windows 8 and newer OS, Linux and Mac OS will install FTDI driver automatically, except Chrome OS. For details of OS compatibility and installation guidance, please scroll down this page and take a look at 'Product description'
Typical applications: USB to RS232/RS422/RS485 converters, Support EEPROM, Vendor ID re-write, unbrick routers and Mprog3.5, interface to GPS modules, flash firmware on hard drive, update transmitter, interface to set top box and more
You will get: 1 x Moyina USB to TTL Module + 1 x Jumper + 10 x Dupont Cables (7.9”, female to female), which are packed by antistatic bag. We offer 1 year guarantee on product, your satisfaction is our passion
----------------------
SKU: HC40111
Polaron Data Sheet
